- Published on
How to Virginize VGS2NAG2 with Vediamo – Simple Step-by-Step Guide
Mercedes-Benz Advanced Coding, Programming & Retrofit Course
$1,855.00 - $4,550.00 $1,555.00
Master Mercedes-Benz ECU coding, programming, diagnostics, and retrofitting with our professional DTS Monaco training course. Learn step by step with a 300+ page digital manual, real workshop examples, ECU flashing, offline variant coding, retrofit wiring, and troubleshooting. Choose Your Account: - Basic: Mercedes Coding, Programming & Retrofit Digital Course Manual. - Full: Course Manual + Cloud Coding Sheets + Software Downloads + Technical Support via WhatsApp & Email. Ideal for automotive technicians, ECU specialists, and Mercedes-Benz repair workshops.
Don’t worry—it’s not as complicated as it sounds. With Vediamo and a bit of patience, you can get the job done right the first time.
Before diving into the how-to, let’s quickly touch on the why.
Virginizing the TCU basically means resetting it to factory mode. It’s a must if:
- You’re replacing a used TCU with another one
- You want to perform SCN coding or online updates
- You need to clear old data for fresh transmission programming
What You’ll Need Before StartingMake sure you have:
- A laptop with Vediamo installed
- OBD-II diagnostic interface (like C4, C5, or C6)
- Stable power supply for your vehicle and laptop
- The VGS2 virgin file ready on your PC
Step-by-Step: How to Virginize VGS2NAG2 Using Vediamo
Step 1: Connect to the Vehicle and Launch Vediamo
- Hook up your diagnostic interface via the OBD-II port.
- Open Vediamo on your laptop.
- From the list of available projects, select VGSNG2.
- Wait for the software to recognize the TCU. You’ll know it's connected when the green light appears.
- Inside Vediamo, head to the “Sequences” tab.
- Choose Execute. This function prepares the control unit to accept changes.
- Let it finish without interruptions.
- Find your VGS2 virgin file. It usually has a .cbf or .smr-d extension.
- Load it into Vediamo using the correct function (typically under “Coding or Flashing”).
- Double-check you’ve selected the correct file for your module version.
- Now comes the important part—hit Start.
- Vediamo will write the virgin data to the TCU.
- Be patient. It can take a few minutes depending on your system speed.
- Once the process completes, check the module’s status.
- If successful, the TCU will no longer show any personalized data.
- Some users recommend turning the ignition off and on again to refresh the ECU list.
Tips for a Smooth Virginization
- Don’t rush. Let each step complete fully before moving on.
- Back up your original TCU data (if possible), just in case.
- Make sure your laptop’s battery is fully charged or keep it plugged in.
- Avoid touching the cables or turning off the ignition during the process.
What Happens Next?
Once your VGS2NAG2 is in virgin state, it's ready for:
- SCN online coding
- Personalization to the new vehicle
- Flashing with a fresh software version
Mercedes-Benz Advanced Coding, Programming & Retrofit Course
$1,855.00 - $4,550.00 $1,555.00
Master Mercedes-Benz ECU coding, programming, diagnostics, and retrofitting with our professional DTS Monaco training course. Learn step by step with a 300+ page digital manual, real workshop examples, ECU flashing, offline variant coding, retrofit wiring, and troubleshooting. Choose Your Account: - Basic: Mercedes Coding, Programming & Retrofit Digital Course Manual. - Full: Course Manual + Cloud Coding Sheets + Software Downloads + Technical Support via WhatsApp & Email. Ideal for automotive technicians, ECU specialists, and Mercedes-Benz repair workshops.