Sirius
ECU supports the following programming modes:
Read FLASH
Record FLASH
Attention! All of these commands must be executed on the computer, which is in the programming mode, except for the command "Link", which is used to transfer the diagnostics mode to the programming mode.
Read FLASH
Record FLASH
Attention! All of these commands must be executed on the computer, which is in the programming mode, except for the command "Link", which is used to transfer the diagnostics mode to the programming mode.
The loader supports reading / writing FLASH Memory ECU Sirius mode only "on the table" when the computer is in the programming mode (or so-called "bot mode").
The correct size of the firmware FLASH memory for ECU Sirius - 256 KB (262,144 bytes).
Attention! The data control unit no EEPROM. The information is usually stored in the EEPROM memory (data immobilizer and other settings) to the Sirius Computer stored directly in the FLASH memory. This means that the read firmware is specific to each computer, and the other to operate without rebinding key immobilizer will not. Therefore,
there are 2 options modify firmware computer data:
1. Edit Editor calibrations exclusively native firmware.
2. In the case of tuning the firmware from another computer, but with the same label, you must use a special plug-in to ChipLoader program that copies all the data from the original native firmware tuning.
The correct size of the firmware FLASH memory for ECU Sirius - 256 KB (262,144 bytes).
Attention! The data control unit no EEPROM. The information is usually stored in the EEPROM memory (data immobilizer and other settings) to the Sirius Computer stored directly in the FLASH memory. This means that the read firmware is specific to each computer, and the other to operate without rebinding key immobilizer will not. Therefore,
there are 2 options modify firmware computer data:
1. Edit Editor calibrations exclusively native firmware.
2. In the case of tuning the firmware from another computer, but with the same label, you must use a special plug-in to ChipLoader program that copies all the data from the original native firmware tuning.
To put the computer into the programming mode, you need to supply it to close 104 foot C167 processor (28 foot FLASH AM29F200BB memory) to ground through a resistor about 10k (for convenience, it is recommended to use the stylus, similar to this here). After power on the computer (simulation the ignition is switched on a table), you must execute the "Connect". After successful communication you can execute commands on reading records FLASH computer memory.
