ELECTRONIC REPAIR COMPANY
  • HOME
  • AUTO File Services Portal
  • Protarge VI Testers
  • Chip Programmer
  • ECU Books
  • ONLINE Store
  • ECU Repair Manual
  • ECU Fault Locator
  • **Member LOG IN**
  • Auto Tuning Blog
  • Free Download

Bosch ME 7.9.9 Chevrolet Captiva

Attention! All the programming team should always be performed with the control unit, which is transferred to the reprogramming mode other than "Connect", which is used to transfer a block of the diagnostic mode in reprogramming mode.


The loader supports reading / writing FLASH block Bosch ME7.9.9 only in "on the table" when the ECU transferred to the reprogramming mode (or so-called "bot mode").


File Size firmware FLASH Bosch ME7.9.9 - 832 KB (851,968 bytes).
​

To transfer control unit programming condition it must be finalized. The following photo vypayat need resistor space, highlighted in blue, and solder it in place, highlighted in red. After the operations of reading records need to rewire a resistor in place with which the sealed-off.
Picture

Connecting to a computer terminal

1,2,67,68 - ECU GND (all compiled so that you can use either)

18 - continuous voltage supply + 12V (battery)

39 - Turn off the power supply voltage + 12V (ignition)

38 - K-Line

BACK TO CHIPLOADER




Picture

    Contact Us

    Your Name ( First & Last)
    Email
    Country
    This issue or suggestion is regarding
    Tell us how we can help
    Max file size: 20MB
Submit




Contact us

AUTO BLOG

Free counters!

All Rights Reserved, ©2011  Electronic Repair Company

http://www.bmweg.com/
  • HOME
  • AUTO File Services Portal
  • Protarge VI Testers
  • Chip Programmer
  • ECU Books
  • ONLINE Store
  • ECU Repair Manual
  • ECU Fault Locator
  • **Member LOG IN**
  • Auto Tuning Blog
  • Free Download